Buy Low Price From Here Now
Faceshield meets all applicable requirements of American National Standard Institute ANSI Z87.1-1989; This attractive faceshield is comfortable and functional. It features a high impact polycarbonate clear visor that is easily attached. The visor flips up, and stays put, when not in use. The ratchet suspension knob adjusts the size of the frame’s suspension to the user’s head, for a custom fit. A soft padded brow pad helps absorb perspiration, for added comfort.; Applications:; Weed/hedge/tree trimming; Grinding; Chipping/shredding; Power washing; Using power tools
Readmore
Technical Details
- Patented ratcheted suspension for quick and comfortable adjustment- Patented pivot point on frame keeps the visor positioned where you want it
- Padded, sweat-absorbing brow pad.
- Clear impact-resistant visor meets ANSI Z87.1 1989 standards
- V-shaped frame extender enhances visor retention, minimizing flaring at bottom of visor.
See more technical details
By David E. Biggar (Montana)
This faceshield is the best that I have ever purchased, and I have had several in the past. It is easy to use and the shield stays where you put it, instead of flopping down on your face like some do. I would buy more any time I needed them.
By Michael C. Emond
i'm sure there are better ones out there but i was looking for a cheap one for occasional use only. this was a good fit.
By PenMangler (alabama, US of A)
...or your dashing good looks? I have two of these I use in my wood working shop. I used to use only safety goggles around my machines, but goggles fog up and are aggravating. So, I decided to use this faceshield for protection. Not long after this decision, I put this faceshield on my gourd and commenced to turning a bowl on my lathe. Shortly, the lathe gave up the bowl blank that was the size of a orange, while spinning at about 1600 rpm. The wooden blank and its sharp corners hit me in the face on the left cheek below my eye. It felt like a good jab from an experienced boxer...or my wife...when it hit me. You know how you stop and hold your breath waiting for the pain and suffering of an injury? Well, I stood there waiting for the blood but noticed that there was none and the impact had not even hurt. It did scratch the shield, but it did not crack. I picked up the bowl blank and finished my project.
The importance of this incident illustrates a few things: Shop safety is the real deal; if I had only had goggles, I would have had a broken cheek bone; it would have been extremely painful; and the cost of being seriously injured versus not a scratch was only 13 bucks or so. You can replace the shield since it does get scratched up, but it's about the same cost to replace the whole faceshield. It may not provide the safety you need for grinding metal, when fragements become .22 caliber projectiles, so you just wear safety glasses under the shield. But, this shield will protect your soft tissue on that mug of yours much better than a pair of goggles. Think about a piece of hardwood in the nose at about forty miles per hour!
By Rocket Scientist (Georgia)
I liked the device itself very much, both protection and quality are very good, but I can't adjust headbelt in such case, that I can flip the shield with one hand. If I set belt too loose (but comfortable for head), then I need one hand to hold belt and other to raise the shield, to avoid slippage. If I set belt too tight, than it holds on head nicely, but I get headache in 2 minutes...
By P. Foreso (Easthampton, MA USA)
I wanted an inexpensive faceshield but this one was too cheap and did not adjust small enough for my head. It was quite uncomfortable and not worth even $15.
Images Product
Buy MSA Safety Works 817893 Adjustable Faceshield Now
0 comments on "MSA Safety Works 817893 Adjustable Faceshield"
Post a Comment